Cookie Setup

This website uses cookies to provide the best possible functionality.

technically necessary (Session-Cookie)

Privacy | Imprint

Select your language


July 08th, 2022

Together with the 3D printing center of the University of Applied Sciences Südwestfalen, one of our largest pumps was printed using the selective laser sintering process. The exhibit was printed in 13 individual parts, as the printer's installation space of 300 x 300 x 600 mm was too small for our dual pump. Afterwards all parts were glued together and are now in our paint shop. After the processing there will be no optical difference to the original, only the weight will give an idea that this pump exhibit is not meant to be used in big engines. The exhibit can be seen from 06.09.2022 to 09.09.2022 at our booth at the SMM in Hamburg.

At this point, we would like to thank all those involved for their excellent cooperation! 

You can find the complete press release of the University of Applied Sciences Südwestfalen here: Pressemitteilung-Detail (